Some Viulliers piston ring sets unearthed recently.
Found these amongst my Aspera etc. stash, I wonder how I might track down the engine they fit.
A tad too small for A tad too small for my lightweight Villiers engine.
Forums
Possibly for a Villiers 150cc
Possibly for a Villiers 150cc Lightweight.
Thanks for replying wristpin,
Thanks for replying wristpin, but the engine I've shown with one top ring sat in is the one you advised me was 'probably' a 125 or 150cc lightweight, if it is in fact, then the roughly 50 thous end gap means my bore is shot!
I must find a parts book for that engine soon.
Don't know if it has any
Don't know if it has any meaning, but there is a label that says A15 on the 4th photo. The A15 was a 146cc engine
Hi DJD
Hi DJD
dont suppose any are 67mm are they I'm wanting a set for a 250cc MK6A 6 cheers
I doubt they are for a 250cc,
I doubt they are for a 250cc, but I will measure them.
As the box says A15 on the
As the box says A15 on the side that seems likely . According to the book by Jack Sizer the A15 was 65 mm std bore, whereas the MK 15 was 63mm and F15 64mm. E & OE
You've been busy tonight
You've been busy tonight Villiers 98! Thank you.
I was using Firefox when I
I was using Firefox when I made this post, I used it to replace Google chrome when my computer was playing up and found that I was no longer able to type out comments underneath the pictures, maybe I will use Chrome in future to log on here.
Not all providers are the same, if that's the correct term.